- Promi-SD from Lemos International
http://www.lemosint.com/scripts/bluetooth_promi.asp
(kinda expensive, also check out the other BT products they have) - EmbeddedBlue from Parallax
http://www.parallax.com/detail.asp?product_id=30068
(you may need to strap on a BASIC Stamp board) - Bluetooth accelerometer
http://www.gvu.gatech.edu/ccg/resources/btacc/index.html
(it has a serial port BT device in there somewhere, I think it’s one of these:http://www.btdesigner.com/modules.htm
- http://www.vprf.com/vmx.htm
(from SOCALWUG)
commonly refered to as bluetooth serial cable replacement devices they can be found from many diffrent makers. These are fully intergrated modules that take serial in and spit BT out. Most need power of some sort but if you can find one that takes 12VDC then installing it in a car would be cake. Maybe even a small stepdown would work well, some cars even have other voltages running around. It would suck to have to change the battries all the time.
hi,
help me! i ve purchased the bluetooth device promi-sd. when i configure it using promiwin it was always detected by my ipag 1940. however, whenever i integrate it to my circuit containing atmega128 ucontroller i could not have it connected with the pda. how come? please, it would be very helpful if anyone give me a hint
thanks a lot folks